Weatherstation problem

The plan was to build a mobile weather station with an arduino, two old windspeed sensors from the local paragliding school, a temperature sensor, a solar panel and an old cellphone.

As the first part I wanted to read the anemometers. I got them for a bargain from Touch&Go. Only I couldn’t figure out how to read them. It was no simple switch, so I suspected a hall effect sensor. From Flytec I got a schematic how to make the circuit. On the breadboard it worked immediately, but on the PCB, I got no readings. After a bit of measuring and thinking, I added two more resistors, to have the oscillating voltage pass the reference voltage.

Next, I started to calculate the wind direction from the two sensors for X and Y direction. Only then I realized that the windspeed alone is not enough. I would need a sign (+ or -) meaning if the wind blows from the front or back through the sensor. With only the speed I know only the angle but not which quadrant. And the quadrant is actually more important than the angle for me.

Ideas are welcome…

Arduino proto board

3 Replies to “Weatherstation problem”

  1. I have been looking for some time to understand how to interface typical Flytech/Brauniger speed sensor to a small electronic set-up. Would it be possible for you to share whatever information you have on the interface, and better the schematics on how to interface it with eg. an arduino or Raspberry Pi ?

Leave a Reply

Your email address will not be published. Required fields are marked *